Mode d'emploi BRITAX TRIFIX 2

[. . . ] The Warranty does not cover: • natural signs of wear and damage resulting from excessive stress • damage resulting from inappropriate or improper use What is covered by the warranty?Fabrics: All of our fabrics meet very high requirements with regard to colour fastness when exposed to UV radiation. Nevertheless, all fabrics fade when exposed to UV radiation. This is not a material defect, but rather a normal sign of wear which is not covered by the warranty. [. . . ] Cleaning Please be sure to use only genuine Britax/RÖMER replacement seat covers, as the seat cover is an integral part of the child safety seat which plays an important role in ensuring that the system works properly. Replacement seat covers are available from your retailer. • The child seat must not be used without its cover. • The cover can be removed and washed with a mild detergent using the 1) Use is permitted on a rearward-facing vehicle seat (e. g. in a van or minibus) only if the vehicle seat is also approved for use by adults. The seat must not be positioned anywhere where it is in range of an airbag which is being deployed. 2) If there is a front airbag: Slide the passenger seat a long way back and refer to any instructions in vehicle owner’s manual. NEXT CHILD SAFETY SEATS BRITAX RÖMER Child safety seats KID KID plus KIDFIX KIDFIX SICT Testing and certification in accordance with ECE R 44/04 Group 2-3 2-3 2-3 2-3 Body weight 15 - 36 kg 15 - 36 kg 15 - 36 kg 15 - 36 kg Re-fitting the Cover: Simply follow the steps in the opposite order. Caution: Check that the harness straps are not twisted and that they have been correctly inserted in the belt slots on the cover. www. britax. com EDV-NR. : 2000026969 01/17 22 31 1. Press the recline handle 10 upwards and slide the seat shell 18 to the rear into the upright position. 2. Loosen the harness straps as far as possible. 3. Open the harness buckle 05 (press the red button). 4. Open the Velcro fastener on the crotch pad 20 . 5. Slide the headrest 03 to its lowest position. 6. Remove the cover of the headrest 31 . 7. Open the poppers on the left and right of the rear part of the cover. 8. Fold the rear part of the cover onto the seat surface. 9. Thread the harness straps through the cutout in the cover. 10. nhook the elastic seam of the cover under the edge of the seat shell. U TIP: Start at the handles on the side and at the upper edge of the seat shell. 11. Pull the cover up and over the bezel of the strap adjuster. 12. eed out the harness buckle 05 and the end of the strap from the cover. F 13. ull the cover upwards a little and then put it with the cutout over the headP rest 03 . On seats featuring: ISOFIX attachments (between seat surface and backrest) and Top Tether anchoring points (for example on the parcel shelf, on the floor or behind the backrest) (Please observe the applicable regulations in your country) Yes 2) Take the time to carefully read through these instructions, and always keep them ready to hand in the designated pocket on the child seat. For the protection of all vehicle occupants In the case of an emergency stop or an accident, persons or objects which are not properly secured in the car can cause injury to other vehicle occupants. For this reason, please always check that. . . [. . . ] Check that the child safety seat is correctly attached and make sure that your child is properly secured. Teach your child about the dangers involved. Removing the child safety seat with ISOFIX 1. Unhook the snap hook 26 from the anchoring point and lay the Top Tether 14 to the front over the child safety seat 3. Press on the grey ISOFIX unlocking buttons on the left and right-hand side of the seat shell 18 . [. . . ]