Mode d'emploi DE DIETRICH DKR7580X

[. . . ] Check the overall condition of the appliance. Note any observations on the delivery bill and keep a copy. Your appliance is designed for normal use in the home. It is not designed for commercial or industrial use, or for purposes other than those for which it was designed. [. . . ] The minimum distance between the cooker hood and the cook top must be 400 mm. Never put your hands in the field of action of the cooker hood extractable unit, during handling operations. 25 - MOUNTING THE HOOD Installation must conform to the regulations in force regarding the ventilation of enclosed environments. In France, these regulations are container in the DTU 61. 1 of the CSTB. In particular, discharged air must not be channelled into a conduit used for exhaust discharge or discharge from devices that operate with gas or other combustible materials. The use of unused conduits is not permissible without the approval of a qualified technician. - DESCRIPTION OF THE APPLIANCE 26 2/ HOOD INSTALLATION EN A correct installation must be carried out for the good functioning of the downdraft. 1) Make a rectangular hole in the rear part of the furniture’s surface suitable for the dimensions of your hood (Fig. 2) If a gas hob is utilised, the minimum distance from the rear edge of the cooking hob to the downdraft must be at least 50 mm. The DHD1101 model must be installed between two cooking hobs with a maximum of two gas rings each. 3) Before cutting the hole, check that there are no internal structural parts of the furniture or other elements in correspondence to the hood zone that could compromise the correct installation. To permit the installation, verify that the overall dimensions of the hood including its motor are compatible with the furniture. The motor is delivered already attached to the equipment so as to avoid any damage during transportation. 5). - REMOTE MOTOR INSTALLATION It is possible to install the motor in a remote position from the cooker hood, but it is necessary to order the DHK900 - 989580001 kit. 28 - REMOVAL OF THE FILTER CARTRIDGE - MOUNTING THE CARBON FILTER The cooker hood must be in the open position to install and remove its grease filters and charcoal filters. Remove the front panel by simultaneously pulling on the upper part of each side (Fig. The panel will rotate forwards to make it possible to access the grease filters (Fig. Remove the grease filters to access the carbon filters (Fig. The carbon filters should be changed according to the frequency of downdraft use and in any case, once every 6 months. Warning: the stainless steel panel that protects the filters needs to be repositioned correctly. Incorrect positioning can cause the hood to stop completely. - ELECTRICAL HOOK UP OF THE HOOD USEFUL ADVICE: We recommend fitting the electronic board at a height of at least 10 cm from the ground and at a suitable distance from all heat sources (e. g. , the side of an oven or cook top). This appliance is fitted with an H05 VVF 3 conductor, 0. 75 mm2 (neutral, phase, and ground) power cable. This can be hooked up to a 220 – 240 V mono-phase electrical network by way of a CEI 60083 regulation power socket that must remain accessible after installation, in conformity to installation regulations. We decline all responsibility in case of accident caused by a lack of ground connection or incorrect ground connection. If the power cable is damaged, call the after-sales service to avoid any risk. ELECTRIAL HOOK UP This appliance conforms to the European Directives 2006/95/EC (Low Voltage Directive) and 2004/108/EC (Electromagnetic Compatibility). When you install the appliance and carry out maintenance, it must be unplugged from the power source or the fuses must be disengaged or removed. [. . . ] key to stop the carriage 2. When the carriage has reached a height of 18 cms press the rising. 3. Press the key and then the key within 2 seconds. The hood carries out the calibration of the filter unit by shifting the carriage up and down by a few cms. During this phase the keys on the keypad flash. When the calibration is finished, press the key so that the hood closes. [. . . ]