Mode d'emploi JEEP WRANGLER 2018

[. . . ] 2018 18JL-126-AC ©2018 FCA US LLC. Jeep is a registered trademark of FCA US LLC. OWNER’S MANUAL 3rd Edition Rev 2 Printed in the U. S. A. All-New Wrangler VEHICLES SOLD IN CANADA With respect to any Vehicles Sold in Canada, the name FCA US LLC shall be deemed to be deleted and the name FCA Canada Inc. DRIVING AND ALCOHOL Drunken driving is one of the most frequent causes of accidents. Your driving ability can be seriously impaired with blood alcohol levels far below the legal minimum. [. . . ] Place the gear selector in PARK, then push and release the ENGINE START/STOP button. The ignition will return to the OFF mode. 3. If the gear selector is not in PARK (with vehicle stopped) and the ENGINE START/STOP button is pushed once, the transmission will automatically select PARK and the engine will turn off, however the ignition will remain in the ACC mode (NOT the OFF mode). Never leave a vehicle out of the PARK position, or it could roll. If the gear selector is in NEUTRAL, and the vehicle speed is below 5 mph (8 km/h), pushing the START/ STOP button once will turn the engine off. The ignition will remain in the ACC mode. If the vehicle speed is above 5 mph (8 km/h), the ENGINE START/STOP button must be held for two seconds (or three short pushes in a row) to turn the engine off. The ignition will remain in the ACC mode (NOT the OFF mode) if the engine is turned off when the transmission is not in PARK. NOTE: The system will automatically time out and the ignition will cycle to the OFF mode after 30 minutes of inactivity if the ignition is left in the ACC or RUN (engine not running) mode and the transmission is in PARK. 6 308 STARTING AND OPERATING ENGINE START/STOP Button Functions — With Driver’s Foot OFF The Brake Pedal (In PARK Or NEUTRAL Position) The ENGINE START/STOP button operates similar to an ignition switch. To change the ignition modes without starting the vehicle and use the accessories, follow these steps: 1. Starting with the ignition in the OFF mode, 2. Push the ENGINE START/STOP button once to place the ignition to the ACC mode (instrument cluster will display “ACC”), 3. Push the ENGINE START/STOP button a second time to place the ignition to the RUN mode (instrument cluster will display “ON/RUN”), 4. Push the ENGINE START/STOP button a third time to return the ignition to the OFF mode (instrument cluster will display “OFF”). AutoPark AutoPark is a supplemental feature to assist in placing the vehicle in PARK should the situations on the following pages occur. It is a back up system and should not be relied upon as the primary method by which the driver shifts the vehicle into PARK. The conditions under which AutoPark will engage are outlined on the following pages. WARNING! • Driver inattention could lead to failure to place the vehicle in PARK. ALWAYS DO A VISUAL CHECK that your vehicle is in PARK by verifying that a solid (not blinking) “P” is indicated in the instrument cluster display and on the gear selector. If the ؆P؆ indicator is blinking, your vehicle is not in PARK. As an added precaution, always apply the parking brake when exiting the vehicle. • AutoPark is a supplemental feature. It is not designed to replace the need to shift your vehicle into PARK. [. . . ] . 58 Tire And Loading Information Placard. . 301, 473, 480, 485 Aging (Life Of Tires) . . 481 INDEX 609 General Information . . 469, 470 Pressure Monitoring System (TPMS) . [. . . ]