Mode d'emploi WHIRLPOOL ADG 7622 WH MODE D'EMPLOI

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. (see at right for options description) Options and display description SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. PROGRAM SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” below). START/RESUME BUTTON Push this button to start the selected program: the indicator lights up and goes off at the end of the program. [. . . ] Clean spray nozzles under running water (use toothpicks if necessary). . . Spray arms Remove blockages/ deposits. GB -5- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. . . . is not working/will not start Possible causes. . . The dishwasher door doesn’t close. “Delayed start” option is ON. Kinked water inlet hose or clogged inlet filters. Too little water in the dishwasher’s water system. Always store oo detergent in a dry place and do not store it periods of time. - For heavily soiled crockery, select a wash program with a higher temperature (see table of programs Temperature not high enough for heavily soiled crockery. Loading of the dishwasher using lower and upper rack - If you select the “Half load/Multizone” option (if available), remember to load only the upper rack or only at the same time with “Half load/Multizone” option. the lower rack to increase washing power and thus obtain optimum wash results. - In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive Frequent use of Eco 50°C. - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 5, Clogged spray arms, dirty filters or not fitted correctly. Spray arms stuck impeded by crockery or cutlery. - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. GB -6- What to do if. . . Crockery and cutlery. . . . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry Possible causes. . . - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2, “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “Delayed start” option). [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. [. . . ]