Mode d'emploi WHIRLPOOL AWZ10CD

[. . . ] Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk (keep to care label!), linen, wool and viscose marked as handwashable. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. i Yes i i i i i i i i i max. Synthetics 40 - 60°C Delicates 30°C Mixed 40°C Syntetyczne 40 - 60°C Delikatne 30°C Mieszane 40°C 3. 0 1. 5 3. 0 i i – Yes Yes Yes i i i i i i i i i i i i i – – i i – i i i i – i i i i max. [. . . ] The indication lamp over the “Start delay” button lights up and goes off when the programme starts. • Once having pressed the “Start/Pause” button, the countdown of the time delay begins. The time delay indication on the display disappears when the programme starts and is replaced by the remaining time. • After the “Start/Pause” button has been pressed, the number of hours preselected can be reduced by pressing again the “Start delay” button. To cancel the “Start delay” . . before you press the “Start/Pause” button: • Turn the programme selector to another position or press the “Reset/Drain” button. . . after having pressed the “Start/Pause” button: • Press the “Reset/Drain” button for at least 3 second. The start delay indicator light goes off. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The display shows the remaining programme time. Due to variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. • Press the “Reset/Drain” button for at least 3 seconds. Any existing water is drained out before the door can be opened. 47 68 40 61 62 62 Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Standard Cotton programme and basis for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature. *** After programme and spinning with maximum selectable spin speed, in default programme setting. PREPARATION OF THE WASH CYCLE 1. Load the machine, close the drum doors and check that they are properly locked. 2. Add detergent and eventual additives as described on the front page and in your Instructions for Use. 4. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the lamp next to the “Start/Pause” button flashes. [. . . ] • The light of the “Fresh care” button will blink while this function is active, and the display will show an animation. • The periodic tumbling will last up to approximately 6 hours after the end of your wash programme, and you can stop it at any time by pressing the “Fresh care” button. It will last a while until you can open the door. • After the “Fresh care” period has run out, the display indicates “End”. [. . . ]