Mode d'emploi WHIRLPOOL AZA9682

[. . . ] • The manufacturer declines all liability for damage to property or injury to persons or animals due to noncompliance with the directions given in these Instructions For Use. Removing the packaging and inspection • After unpacking, make sure that the dryer is undamaged. Contact the After-Sales Service or your local retailer. • If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. [. . . ] • Never stop a tumble dryer before the end of the drying cycle, unless all items are quickly removed and spread out so that the heat is dissipated. • This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). • By ensuring that this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. • Always set the programme/time selector knob to the “0” position after use. This prevents the dryer from being switched on accidentally. • Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. • To clean the outside of the dryer, use a neutral detergent and a damp cloth. • The final phase of a drying cycle always occurs without heat (cool-down phase) so that the items are left at a temperature which ensures that they will not be damaged. • Wipe away any lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. • Since lint can penetrate through the filter, it is necessary to clean the entire filter area (including below the filter) from time to time using a brush, a damp cloth or a vacuum cleaner. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse. If the fuse cover is lost, the plug must not be used until a correct replacement is fitted. Correct replacements are identified by the colour insert or by the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of United Kingdom will frequently apply, but a third type of plug and socket is also used, the 2-pin type with side earth terminal. 3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instructions. Please do not attempt to change the plug yourself. This procedure must be carried out by a qualified Whirlpool technician in compliance with the manufacturer’s instructions and current safety regulations. 18 DESCRIPTION OF THE DRYER A. Door: To open the door, pull the handle. To close the door, push gently until closed. Heat exchanger flap REMINDER - MAINTENANCE AND CLEANING Before cleaning or carrying out maintenance, switch off the dryer. AFTER EACH DRYING CYCLE • Clean the lint filter at the end of every drying cycle. [. . . ] Make sure that the ambient temperature is between 5°C and 35°C. If the failure reoccurs, please call the After-Sales Service. F06 F07 F10 - 15 F18 F19 F20 F21 F22 Please call the After-Sales Service. If the failure reoccurs, please call the After-Sales Service. If the failure reoccurs, please call the After-Sales Service. [. . . ]